Base Moulding Installation

If you're going to be doing any base moulding installation, then there are a few things that you need to keep in mind before you start. Base moulding installation is not difficult, but you do need to be careful to use the proper techiniques, otherwise it will not look very good. The reason for this is that improperly installed base moulding will end up with large gaps between the pieces, joints that don't match up, and it will not fit in the corners of your room.

Extra Moulding Leeway for Mistakes

The first thing that you need to do when you're getting set up for a base moulding installation is to measure every wall in your room. Make sure that you get the exact measurements, because those will be important later. For right now, you just need to know how many feet of moulding you need to buy.

Make sure that you add at least an extra foot to the measurement for each wall. This way, you'll have some extra moulding to work with in order to figure out your mistakes.

The key things to rememeber about base moulding installation is that it works the same way as installing any other type of trim. You need to make sure that all of the joints are tight, and you should also make sure that everything is straight. When you're installing base moulding on walls, however, you will have to deal with the fact that most of the time, the walls will not be completely flat. There will be bumps, uneven plaster, or even strangely aligned studs.

Deal with Gaps after Installation

For base moulding installation, the easiest thing to do is just to cut the base moulding, install it correctly, and then go from there as far as getting rid of gaps between the moulding and the wall.

There are two major options for getting rid of the gap between moulding and wall. First, you can probably just bend the moulding toward the wall. Second, you can also use some caulk to just fill up the gap.

When you are measuring for the corners of your room, you need to make sure that you are cutting the corners correctly. First of all, none of the corners in your room will be exactly 90 degrees. This is due to the slightly uneven corners and walls in your home.

The best way to figure out what angle you need to make the cuts at is to cut each of the pieces of base moulding at a 45 degree angle. Then, try to fit them together inside of the corner. If they don't fit exactly, try again! This is why you have so much extra baseboard moulding to work with.

Start at the Door

Another thing to keep in mind when you're doing a base moulding installation is that it is easier to do the installation if you start at your door and then work your way around the room. Make all of the measurements first, but you should not necessarily make all of your cuts until you have reached that portion of the wall, otherwise you might find that you do not have the correct size of moulding.

Base moulding installation is not difficult, as long as you are careful. Just make sure that you measure everything more than once to get the right measurement. With a little bit of patience and hard work, you should soon have your base moulding installed.

Our Most Popular Online Tips