Carpet Fitting Tips

carpet fitting tipsChoosing carpet for a home is a major investment, but one that has a lot of advantages over other flooring types. The style selection is massive, newer carpets are very easy to care for, and carpet is comfortable and stylish. When laying a carpet, a few carpet fitting tips may be necessary to ensure that the job goes as quickly and easily as possible. The main carpet fitting tips are about the measurement process and the tools needed for the job.

Measuring for Carpets

Calculating the amount of carpet needed is very important when doing any fitting, to keep the seams to a minimum. The room or rooms that are to be fitted should be measured to the exact measurement, and from every angle. One carpet fitting tip is to remember that some rooms may have a fireplace or other fixture that the carpet will have to fit around- do not forget to take the measurements of that area.

The Tools of the Trade

There are several specialized tools that are necessary when fitting carpets. One carpet fitting tip is that some of the tools may be rented at your local home improvement store rather than bought outright.

Tackless strips are strips made of wood, or sometimes metal, that have a few rows of pins that will be used to secure the carpet. They must be fastened to the floor near to the walls of the room.

A carpet stretcher, also known as a knee kicker, is necessary to stretch the carpet to meet the tackless strips, and will make the carpet tight enough that it will not later bulge or ripple. One carpet fitting tip is to rent this tool if it is only to be used for a week or so. If you need it for more time than that, it might be more economical to purchase one.

The carpet should be cut with a very sharp carpet cutting blade, so it is important to buy several blades, as they dull easily. A dull blade may snag the carpet or cause other damage. An important carpet fitting tip for this phase is to remember that carpet blades are double sided and sharper than most normal utility knives, so it is easy to make a mistake and injure a finger. A carpet iron may be necessary to heat hot melt glue to fasten seams together.

Cutting the Carpet

Cutting the carpet may be the part most fitters dread, as mistakes can be costly and frustrating. To cut the carpet, you will need to heed closely the measurements that you took, and to be sure not to cut too far into the carpet. It should be rolled out to the proper length, and a few inches should be added to the length on each edge just to make sure of the fit. A standard carpet fitting tip is to be sure to cut the carpet from the back and not from the pile side.

Once the carpet is laid out in place, and stretched so that all wrinkles are gone, you can trim the extra inches off. After the carpet is good and stretched, it can be pulled along to attach to the tackless strips. The carpet will not need tacking from the top, as the strips will keep it attached securely. Seams can be welded together with your hot-melt glue.