A drywall lift rental is an invaluable tool when you are hanging drywall in your home. While it normally takes two, or even three, people to install a piece of drywall, a drywall panel lifter allows one person to do the job. If you are an average homeowner who doesn’t spend 40 hours a week [...]
Some people feel like drywall surfaces in new construction shouldn’t need a layer of primer before it is painted. The fact is, however, paint will go on much more evenly and look better if you go to the trouble to apply a layer of primer to the wall first.
If you fail to do this step, the walls will soak up paint in different amounts depending on whether it is covering joint compound or sheet rock. For best results, prime the surface first.
There are many reasons why a homeowner may decide to remove drywall from their home, but this project should not be undertaken without understanding the proper way to remove drywall. Removing drywall can be a messy process that can take a good deal of time, so forget what you have seen on television about scores of people driving hammers and other tools into the wall to remove drywall quickly.
In order to properly remove drywall, there are steps that should be taken in an orderly fashion to complete the project and minimize the amount of mess that is created.
Modern sheetrock products provide a quick, easy and economical way to produce a uniform finish on a masonry wall, stud-partition or ceiling before decorating it. Sheetrock is available in various types and sizes; and choosing and buying an appropriate sheetrock thickness for the job at hand is essential.
Compared to the practice required to perfect ‘wet’ a plastering technique, any reasonably experienced DIY home enthusiast can work with sheetrock, also known as drywall, to attain a surface good enough for decorating.
Main Types of Sheetrock and Their Thicknesses
There is nothing like standing back and looking at your first drywall project. The fact that just a few days ago you were standing in a half-finished room of joists, studs and exposed insulation that you have since transformed into something that actually looks like a room is very satisfying.
There are some nice tricks to help you with how to texture sheetrock walls. Many homeowners love the dramatic look and feel to texture sheetrock walls in their homes. You can create some very dynamic and dramatic wall looks using texture sheetrock walls instead of traditional flat, painted sheetrock walls. Additionally, textured sheetrock walls help to hide any taped areas and edging areas of the walls.
Gypsum wallboard is traditionally used in homes as the backboard for paneling, fabrics, wallpaper and even tiling. Some homeowners feel a little intimidated when paneling over gypsum wallboard but the process does not have to be complicated or complex. Following some simple guidelines will create huge success for paneling over gypsum wallboard.
Your first step for paneling over gypsum wallboard is to actually put up the wallboard. Traditionally, paneling over gypsum wallboard is sold in four feet by eight feet sheets and is approximately one-half inch in thickness.
There are a few different interesting drywall rolled texture techniques that you can use for both your ceilings and your walls in your home. Adding drywall texture to one or several rooms of your home can add a dynamic effect to the room and create the feel of being in a completely new room. Depending on which of the drywall rolled texture techniques that you use will determine the look and effect that you can achieve.
When sheetrock (drywall is the gypsum board product and Sheetrock is a brand name, but the two words have come to be interchangeable) is hung, or installed, the joints are exposed and the nail or screws dimple the paper face of the sheetrock. Then begins the taping and floating process. To start with, drywall tape is applied to the joints and all the inside corners.
There are two types of drywall tape, the original paper type, and the newer fiberglass or plastic mesh type. The newer mesh type is preferred because of its superior holding power (the mud penetrates the mesh) and because of the fact that it has an adhesive on one side so it is easier to apply.