Crown Molding Tips

When undertaking the final touches that will embellish your home and bring it all together for the look you are aiming for, installing crown molding is no small feat. Sure, it looks easy to install and can break up plain, bland rooms, but there is more to cutting the lengths into the sections you need and tacking them up with finishing nails. These crown molding tips will help make sure the task does not drive you crazy.

Choosing Crown Molding

First of all, you need to choose a crown molding that does not overpower your room or look to thin and out of place. The pros have some great crown molding tips for making the right choice for your rooms. A good rule of thumb is to choose a molding based on ceiling height, allowing 1 inch of molding height per foot of ceiling height. If you have 8 foot ceilings, pick a crown molding that is 8 inches in height. The style of your room and home comes into play too; don't choose a sleek molding for a Victorian house, and avoid fancy moldings for a modern decor.

Extra Tips before Installation

Don't be too precise with your measurements and needs, and always buy more lengths than you think you need. Since crown moldings are made of wood or wood particles, bringing the supplies home and letting them sit in the room they will be installed for ten days or so will help allow the wood to adjust to the room temperature and humidity for a better fit.

Out of crown molding tips, this one has to be in the top ten: Prime and stain your lengths before you set them up for an easy, fast job. You won't have to be careful about getting primer or stain on your walls or worry about drips.

Making the Cut

The biggest problem people run into with crown molding is carrying out the proper cut so that everything fits and you only have to make the cut once. Most individuals tend to cut crown molding the same way as they do baseboard molding, by laying the piece on the flat side. We'll let you in on one of the best crown molding tips: There is a relationship between the angled designs of crown molding and the wall it will be affixed to.

Take a close look at the length of your molding. Notice how the edges are angled on the back of the trim? Your crown molding will be tucked in the corner between wall and ceiling. One edge is designed to be set on the wall, the other fitting against the ceiling.

If you treat these edges the same and cut sections without respecting which edge fits where, none of the crown molding tips the pros give you will help and your fit will be off. Once you understand that the cut you will be making needs to be in relation to which surface it will rest against, the rest is easy.

Practice making cuts with your miter box on a scrap piece of crown molding. Turn your crown molding upside down, to start with. Hold it firmly between the saw fences so that the angled areas are tight against the surface. This is one of the best crown molding tips for cutting your sections properly.

By placing the crown molding this way, you will replicate the hollow spot that exists when the piece is set in place on the wall. Your saw needs to be set at a 45-degree angle, and once you have made a test cut, you will notice that the longest edge of your piece is the one that will be set against the wall.

Final Touches

After that, you are ready to set your molding in place. Some crown molding tips suggest adding filler to the corner between wall and ceiling before nailing your strips into place. Others include decorative tips for a perfect job, such as making sure lengths of crown molding don't join over focal points such as windows, pictures, or fireplaces. If you have to join sections, bevel the joints. Use fine finishing nails and tack your moldings into place being careful not to dent the facing.

Our Most Popular Online Tips