Do It Yourself Drywall Finishing: Taping

You can save yourself some time and effort and get better results by learning a few do it yourself drywall finishing tips. Since taping is one of the fundamental steps in finishing out drywall, we have gathered together a few nuggets of knowledge to help you get this important basic down. Read on to find out more.

Preparing Mud and the Order of Taping

The first step in do it yourself drywall finishing in which you are doing taping entails the joint compound (commonly called mud) you will be using. Joint compound, straight from the bucket, is much too thick. You need to thin it down a little in order for it to work properly and for you to be able to spread it with ease and efficiency. After thoroughly mixing the compound, add a little water to it gradually. When it reaches the consistency of pudding and stays on your drywall knife without sliding off, you have got the mud just right.

There is an order in doing the taping part of do it yourself drywall finishing that many professionals and experienced do it yourselfers follow. First repair any little dings or holes in the drywall, then do the butt and recessed joints, and finally, the inside corner angles. Spread nice even layers of mud four to six inches wide using a six-inch drywall knife. Unless you're in the market for future problems, don't skip any places that need to be smoothed out on the drywall.

Air Pockets are No-Nos

One of the secrets to do it yourself drywall finishing when you tape is making sure to get all the little air pockets out. When you apply the mud, and then place the tape over the section you're working on, press down firmly with your drywall knife and slide it along the length of the tape. You want to see joint compound coming out from both sides of the tape. Otherwise, chances are good that air pockets remain in the mud and will appear as bumps in the final finish of your drywall project.

Neat, Clean Angles

Taping angles during do it yourself drywall finishing takes an extra step in the usual procedure. For a nice, straight angled taping job, such as in a corner, first cut or tear off the tape and crease it down the middle. After you apply your coat of joint compound, press the tape into the corner first with your drywall knife and then go over it with your fingers, pressing down firmly. Again, you'll want to see the mud come out both sides of the tape to eliminate the possibility of air bubbles marring the final finish.

Learning how to do the taping part of do it yourself drywall finishing is best done with hands-on experience. If you can find someone who already knows how to do this, maybe a professional looking for a helper, this is the very best way to learn. Of course, not everybody can do this, so the next best way to learn is by trial and error. Learning how to tape is not rocket science; with a little practice, it won't take long to figure out how to expertly tape drywall to prepare it for a smooth, beautiful finish.