Tips for Installing Baseboard Trim

If you're going to install some baseboard trim, then you should definitely make sure you collect some tips for installing baseboard trim. Trim installation is one of the most difficult things you will have to do while you're remodeling your house, so you should make sure that you do it correctly.

The other thing that you should keep in mind is that some tips for installing baseboard trim will also help you to deal with any setbacks that could get in your way during the installation.

The first problem that you will run into is the fact that most of your walls will not be straight, and in most cases, they will not attach directly to the floor. In these cases, you will have to deal with any gaps that might arise. If the gap is between the baseboard trim and the bottom of the wall, then you will not have too much to worry about.

On the other hand, if the gap is between the baseboard trim and the part of the wall that is visible, then you need to make sure that you eliminate that gap using some of the tips for installing baseboard trim.

Eliminate Gaps with Caulk

There are several ways to get rid of the gap between the baseboard and the trim. Some of the tips for installing baseboard trim recommend that you bend the baseboard toward the wall, and then glue it in place. This is a good option if you are using very thin baseboard trim.

However, if you are using a thicker type of trim, then you might have to use caulk to seal the baseboard to the wall. It is important to make sure that you fill in the gap, so feel free to try other methods as well.

Trial and Error Best Way to Get Corner Cuts

Some tips for installing baseboard trim also affect how you install the corners of the baseboard. Essentially, if you do not have a lot of experience installing baseboard, then you should definitely do a lot of trial and error.

It is recommended that you keep extra pieces of the baseboard around the site of the installation. That way, you can test your joints and see whether or not you need to make adjustments before you install the baseboard itself.

When you go to make a baseboard corner cut, you should first cut two 45 degree angles, and then go from there. Hold the two mitres (the 45 degree cuts) against the corner and see how far they are from exact. Then, change the angle slightly and cut again. This isn't the best of these tips for installing baseboard trim, since you are still left with trial and error, but eventually you should find an angle that will work for installing your trim.

Fit Two Pieces Together at an Angle

Finally, the last of these tips for installing baseboard trim will cover what you should do when you have to connect two smaller pieces of trim in the center of a room. While a lot of people will just try to glue the two pieces together and then install them, you should not do that with straight cuts on the ends.

Instead, make sure that they are angled cuts (angled to about 30 degrees should work). Then, glue the two pieces and install them as normal. Since you'll end up actually nailing the two pieces of trim together, they will be connected in a much better fashion.

Our Most Popular Online Tips